Home / Blog / Press Fittings From ValvesTubesFittings.com

Press Fittings From ValvesTubesFittings.com

M-Press manufactures our press fittings which are available from stock in EN 1057 copper, stainless steel 316 and carbon steel, this includes sizes 15mm to 108mm from stock and includes the corresponding pipe material. What makes ValvesTubesFittings.com stand out from the rest is that we’re a PCC M-Press Distributor offering high-quality products at affordable prices for installers and end users alike.

M-Press fittings can be used on a myriad of installations covering hot water heating systems, potable water installations, compressed air lines, chemical installations as well as natural gas and LPG installations when the correct seals are used, stainless steel and copper press fittings also come with WRAS approval which makes them suitable for potable (drinking) water installations in the UK.

A Quick Installation Guide For M-Press Fittings

The key to a good installation of press fittings is to do it right the first time and every time and for added assurance, we can offer full and free training from the M-Press team. For those experienced pipe fitters here is a quick guide to installing press fittings to ensure that when the job is complete its leak free and covered by the extensive M-Press warranty.

  • Cut the tube square
  • Clean and deburr the ends of the tube internally and externally while ensuring there are no sharp edges.
  • Mark the tube using the M-Press depth gauge
  • Remove any packaging from the fitting and insert the tube into the fitting to the depth marked previously
  • Connect the correct jaws to your pressing machine and place the jaws over the fitting maintaining a 90° angle between the tube and the jaws
  • Start your pressing cycle on your machine and wait for the machine to complete the process, remove the machine once finished
  • Only begin pressing when you’re certain the fitting and the seal are in the correct position
  • Do not attempt to press unsupported fittings or pipe (The correct support brackets must be installed)
  • Please ensure that your pressing machine has an up-to-date calibration certificate

We hope that this quick guide will aid your future installation of the M-Press fittings range and look forward to supporting your business in the future, for further advice please discuss your next project with our sales team.

Disclaimer: Information correct at the time of publishing (March 2019) but is subject to change. E&OE.